Basket
(0)
Rust Convertor
2 in 1: stop rust + primer
Reference : 470105
- 2 in 1 : acts both as a rust stabilizer and as an anti-corrosion primer.
- Use on already rusty metal surfaces.
- Ideal for restoring corroded parts of machinery and metal equipment.
Rust Convertor
Rust Convertor Properties
- Operating temperature: max. 80°C, peak at 150°C
- Dry without dust approximately 30 minutes
- Recoverable after approximately 5 hours (indicative values depending on temperature, coated thickness, humidity)
- Vapor pressure at 20°C: 4 bar
- pH value: 4 -4.5
- Spray flow: 0.8 gr/sec
Composition of the Rust Convertor
Binders: Mixture of polyvinyl butyral, resins & solvents.
Without heavy metals or mineral acids.
Color: Clear brown liquid, turns dark blue/black on the metal after drying.
Propellant gas: Dimethyl ether.
Precautions for use
- Shake well before use.
- Remove paint and rust residue with a wire brush or sander. The surface must be clean, dry and grease-free. When using outdoors, remove any moss or algae deposits. Cover the surrounding areas.
- Spray at a distance of 25 cm from the support.
- Apply several thin layers (+/- 4 layers).
- Between the different layers, allow a drying time of approximately 20 minutes.
- When the last layer is completely dry, It is recommended to sand it to improve adhesion.
CLP labelling with two pictograms.
Dangerous. Follow the precautions.
ACETONE
H222 Extremely flammable aerosol.
H229 Pressurized container: May burst if heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.
Safety data sheets are available free of charge on the internet: www.quick-fds.com.
You might also like