Basket
(0)
Adhesion primer grey
For optimum adhesion of finish coating.
Reference : 424008
- Very good adhesion
- Good coverage. Grey tinted.
- Resists up to 100°C
Adhesion primer grey
High-quality, quick-drying adhesion primer. Prepares surfaces and promotes adhesion prior to finish coating. Multi-surface: stone, wood, metal, etc. Can be used on bare or lightly rusted steel.
Primer Properties
- Excellent adhesion, filling and easy to sand primer
- Temperature resistance: 100°C
- Dust free dry: after 10 to 15 minutes
- Dry to the touch after 15 to 25 minutes
- Recoverable after 12 hours (indicative values depending on temperature, coated thickness, humidity)
Composition of the Primer
Binder: acrylic
Solvent: Mixture of solvents
Propellant gas: Dimethyl ether
424008
Data sheet
- Volume
- 400 ml
- Product type
- Adhesion primer
- Application domain
- Maintenance, Preparion of the supports
- Application area
- Woods, Metal
- Packaging
- Box of 6 cans
Instructions for use
- Thoroughly shake the aerosol for at least 2 minutes before use to ensure the pigments are correctly mixed.
- The surface must be clean, dry and free of grease. Remove all residues of varnish, rust, etc, then sand. When using out-of-doors, remove any moss or algae present on the surface. Cover the surrounding areas.
- Spray at a distance of 25 cm from the surface. Best results are obtained by applying several thin coats in different directions rather than a single thick coat.
- Leave to dry for approximately 20 minutes between coats.
CLP labelling with two pictograms.
Dangerous. Follow the precautions.
ACETONE
H222 Extremely flammable aerosol.
H229 Pressurized container: May burst if heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.
Safety data sheets are available free of charge on the internet: www.quick-fds.com.
- Very good adhesion
- Good coverage. Grey tinted.
- Resists up to 100°C