TRACING® line marking spray paint is used to delimit surface areas and optimise traffic by tracing lines inside or out: Logistical warehouses, sports complexes, grassed pitches, cycling tracks and car parks. This line marking paint is intended more for ground markings on surfaces with little wear. It is the best quality/cost compromise for outside marking.
This product is no longer in stock
|Quantity (by box unit)||Discount||You Save|
|10||68,70 €||Up to 687,00 €|
|Packaging||Box of 6 cans|
|Product type||Line marking spray paint|
|Application domain||Signalling and events, Line marking, Ground signage|
|Application area||Concrete, Bitumens, Metal, ...|
The 750ml offers the best value for money for outdoor marking.
DANGEROUS. FOLLOW THE PRECAUTIONS.
|Line width 4 cm to 10 cm||1 x 500 ml aerosol||1 box of 12 x 500 ml aerosols||1 x 750 ml aerosol|
|1 coat||2 coats||1 coat||2 coats||1 coat||2 coats|
|Slow application||50 m||25 m||600 m||300 m||100 m||50 m|
|Rapid application||75 m||37 m||900 m||450 m||150 m||75 m|
Pigments: mineral and organic, lead and cadmium-free
Solvents: a complex blend free from chlorinated solvents and aromatic compounds (toluene, xylene, etc)
Propellant: a specific mix of isobutane and propane
Safety data sheets are available free of charge on the internet: www.quick-fds.com.
No paint mist or drips during use.
CLP labelling with a single pictogram.
H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
EUH208 Contains TALL OIL FATTY ACIDS,COMPOUNDS WITHOLEYLAMINE. May produce an allergic
Whatever the nature of the surface, the following conditions are essential for the optimal application of TRACING®
Correct preparation of the surface to be painted is imperative to obtain excellent paint adhesion.
Thoroughly clean the surface to ensure that it is free from dust, dirt, grease, etc.
Relative humidity should be between 10% and 50%.
The application temperature should not be below 5°C.
For a good quality line, the first coat should be applied quickly (print layer); on the other hand, the second and optional third coats should be applied more slowly to obtain the desired coverage.
Before applying Tracing® to a new concrete surface, allow a minimum of 3 to 4 weeks for complete drying (French building trades standards) and the elimination of acidity.
It is advisable to wait at least 15 days before line-marking a new asphalt surface in order to avoid any alteration to the quality of the marking.
In this domain, there are several different types of paint and the paint used for the floor may be incompatible with TRACING® (resulting in poor adhesion). We therefore recommend carrying out a test beforehand for these specific types of surface.
Lines can be given a protective coating of our PROTECT LINE varnish for improved longevity and dirt resistance.
Aucun article du blog en relation