DITYPUMP

DISCOVER THE DITYSPRAY SYSTEM

The DITYSPRAY refillable spray can system is a real revolution and alternative to the classic aerosol. Today, this system is the only air conditioning solution that uses compressed air as a propulsion force in a rechargeable and transparent suitcase ! It is ideal for confined or high-risk working environments and allows all kinds of products to be applied while respecting people and the environment.

KNOW MORE ABOUT THE DITYPUMP

The suitcase equipped with a compressor for an autonomous and mobile access to compressed air, rechargeable on sector or cigar lighter. It also comes with a DITYBOX.

SEE THE INSTRUCTIONS FOR USE

INTRODUCTION

 
DITYPUMP has been designed for pressurization of DITYBOX autonomously and in a movable way. The integrated compressor
(ID : Modo1-C) allows the pressurization until 8 bars. The battery « Li-ion rechargeable » (ID : 44-092-001) is rechargeable on
power supply and cigarette lighter.
For operator safety, READ AND UNDERSTAND THE MANUAL thoroughly before use and SAVE IT FOR FURTHER REFERENCE.

IMPORTANT INFORMATION & WARNINGS

BEFORE USE

• Inspect air compressor, batteries, plugs, charger cords and cables before use. If cracked, broken or damaged parts are found, do not use it.
• Only use an ActiveTools® approved charger. Only use accessories and parts specified in the instructions.

 
WORK AREA SAFETY

• Never use the air compressor near flammable fluids or gases. Make sure your working area is well-lit.
• Never expose the air compressor or battery to rain, frost and temperatures under 0°C (32°F) or above 40°C (104°F). Never change the battery in humid or wet location.
• Stay alert. Always pay attention to what you are doing when working with the air compressor, charger and battery.
• Do not use the compressor unit in a potentially explosive atmosphere.
• Keep away from Children. The air compressor is not a toy.

 
TOOL USE AND CARE

• DITYPUMP keeps memory of preset pressure level of your last use.
• DITYPUMP is designed for occasional use. Inflation over a long period will overheat the air compressor and will cause damage.
• Do not use it for more than 5 minutes continuously, and must be switched off and set aside to cool for at least 15 minutes. If the air compressor emits abnormal sounds or overheats, turn it off immediately and let it cool off for minimum 30 minutes.
• The dust cap is designed to protect the power inlet from the dust.
• Always put it back to the place when not in use.

BATTERY USE AND CARE

• To make the most of the compressor, always fully charge the battery before use.
• Do not use the compressor during the charging process of the battery.
• Do not open, dissemble, crush or burn the Li-ion Battery Pack.
• If you are going to store DITYPUMP for a long term as more than 3 months, it is recommended to pull out the Li-ion battery pack and store with air compresor separately. And it is recommended to recharge the Li-ion Battery Pack periodically.
• Do not expose the Li-ion battery pack to heat or fire. Avoid storage in direct sunlight. Do not store together with oxidising and acidic materials. Keep out of reach of children.

WHAT NOT TO DO

• Do not use a DITYBOX that appears cracked.
• Do not use a leaking DITYBOX.
• Do not attempt to repair a damaged DITYBOX.
• Do not attempts to open the spray before it is empty.
• DO NOT CHARGE THE DITYBOX WHEN THE COMPRESSOR IS CHARGING.

Guaranteed 3 years parts and workforce.

DITYPUMP INSTRUCTIONS FOR USE

	1) Screw out the empty DITYBOX cap.
	2) Screw out the DITYBAG cap and fill it into DITYBOX.
	3) Screw in cap onto DITYBOX to make airtight the system.
	4) Switch on the power by pressing On/Reset button and select unit by pressing it again.
	5) Adjust pressure level at 5 bars by pressing the Up / Down button. When you stop pushing it, the digital on display will flash 3 times to indicate a pressure level has been set. Then, it will go back to 0. It is ready to inflate.
	6) Match the connection of the inflating valve of DITYBOX on the compressor and press it down to supply in air. Press the trigger again to stop or the compressor will automatically stopped when the pressure reached the preset pressure. Always switch off the device properly after the device auto-stopped.
	7) Spray your product
	8) Screw out the cap of DITYBOX.
	9) Screw out the cap of DITYBOX.
	10) Take out DITYBAG and close the cap.
	11) Screw in the cap on DITYBOX.